Cost-effective solution in the building applied by AEON Satisfaction has achieved high efficiency when operating the building. Just by performing a few basic operations, you have significantly reduced your household electricity costs, while causing minimizing CO2 exhausts to the environment.
Setting up energy saving solution for household appliances:

1 ) Raise the temperature of the refrigerator

Refrigerators take in about 20% of electricity when compared with most household home appliances. Guarantee the power cutting down mode switch is always turned on. Check the gaskets around the case door to be sure they are clean and tight.

installation payments on your Place the washing machine in warm or cold drinking water mode, avoiding hot rinse setting

This will help reduce about 227 kilogram of CO2 for electric heating and 68 kilogram CO2 for gas normal water heating.

3. Ensure that when the bowl can be used, the bowl must be loaded in the container

You are able to turn off the dish drying mode. This will save you 20% of the electricity used for dishwashers.

4. Decrease the temperature of the hot water heater

Instead of setting the temperature to 600C, set 500C. To get example, if every family reduces the temperature of the hot water container to 100C, we will reduce 45 million plenty of CO2 emissions each year.

5. Choose energy-saving products when replacing old appliances

Choose to buy products that are suited to your family's needs and have energy-saving labels. To get example, a horizontal parrot cage washer can save 60 per cent to 70% of the water used compared to a vertical cage.
Strength saving solutions in structures effectively.

Energy saving alternatives in buildings effectively.
Strength saving solution in the building for cooling and heating systems:

6. Carry out not overuse the heaters and air conditioner

Only reducing two degrees of heating in the cold weather will also help reduce 6% of CO2 emissions, similar to 191 kg of CO2.

six. Regularly clean and replace filters

The energy lost at conditioning and the heater must work through a dust-covered filter. Washing the filter will save 5% of energy and minimize 80 kg of CO2 emissions.

8. Employ economical compact ball to give best light result

Although the investment price from the head is bigger than the normal bulb, the compact ball is calculated in a long time, it will probably be more economical due to only using 1/4 power and with a life span of 8-12 times higher than the ball. Typical lights that still provide the same brightness. When ever lighting a normal light bulb, only 10% of the electricity is employed to light up and the rest of the 90% of the electricity is merely used to make the bulb warm up.

9. Insulation of hot water systems costs only 10-20 USD but will save 450 kg of gas for hot normal water heating

10. Use less hot water by setting up a nozzle to regulate normal water flow

It costs about 10-20 USD but actually will reduce about 600 kg of CO2 exhausts annually and save two hundred kg of gas.

10. Self-air conditioning in your building

Cover air water leaks on windows or doorways. This is only about $ 1 per windows and will reduce two, 500 kg of CARBON DIOXIDE emissions. Ask the in order to perform an energy audit to verify if your home uses energy successfully. This service may be free or usually a very small price.
Inexpensive solution in the dual building with moving

doze. Should walk, bike, carpool or use public tools whenever possible

For example, if your car or truck is 30 kilometres away, it will ingest 3. 8 liters of gasoline, you could reduce 3, 200 kg of CARBON DIOXIDE each year.

13. The moment conditions are available for new vehicles, choose a fuel-efficient model

Instead of spending 3. 8 lt of gasoline only 31 km away, if your car is 64 kilometres away and the gasoline consumption is equivalent and you go 16, 500 km per year, you will reduce about six, 000 kg of CARBON emissions waste.
Energy vehicle solutions in the home: reduce, reuse, recycle for cash

13. Reduce the amount of domestic waste

By top secret to minimize the use of pre-packaged products or use reusable and recyclable products. Cutting or recycling where possible every kilo of spend out in to the environment, you will save energy and minimize at least zero. 5 kg of CARBON emissions.

15. If your car has air health installed, recycle the refrigerant of this system

Seapage from the car air conditioning product is the key cause of CFC emissions, a substance that causes punctures of the ozone part and causes a temperatures rising a result of the earth. This CFC is the same as practically 10 tons of CARBON emissions per year.
Make your building renovation to save energy, please apply the following solutions:

16. Padding for walls and rooftops

This reduces energy costs by 20% to thirty percent and reduces 300 kilogram to 2, 500 kilogram of CO2 emissions each year

17. Modernizing the window system

Replace traditional door samples with 2-layer glass doors. Making use of this a glass window can reduce two. 4 tons of LASER annually for heating gas apartments, 3. 9 loads for oil heating systems and 9. 8 loads for electric heating systems.
18. Planting trees and light-colored walls

If you are in hot climates or paint in dark colors, you stay in a cool climate. Reducing energy intake by utilizing the tone of trees using appropriate paint colors may help you reduce up to installment repayments on your 4 lots of CO2 per yr.

Energy saving solution in the building for control and community work:

nineteen. Propose your boss to install energy-efficient equipment and practice energy-saving measures and minimize workplace emissions.

End up being on the market or attend local societies and teams and work with authorities to apply these measures in schools and public Works buildings.

20. Address with local and national environmental authorities, highlighting your thoughts about energy efficiency and giai phap tiet kiem nang luong cho toa nha conservation as well as environmental hurdles.

Dirección editorial:
Facultad de Arquitectura. Universidad Tecnológica de La Habana José Antonio Echeverría, Cujae
Calle 114 #11901, entre Ciclovía y Rotonda. Marianao 15. La Habana. CP 19390. Cuba.
Teléfonos: (53) 7267 1134
E-mail: revista_au@arquitectura.cujae.edu.cu